Categories
Tips

Has Spring Sprung?

While there are some important spring HVAC maintenance tasks you can take on yourself, many others can only be safely performed by a professional. Call AC Dave heating & Air to schedule your Spring check.
Airflow within your home:
Replace the filter. If you do not know where your system’s air filter is, or how to replace it, ask your HVAC pro to show you.
(Here at AC Dave Heating & Air, we replace your filters as part of our maintenance agreement.) Then, change your filters regularly. How often depends on your system and the type of filters your use. When in doubt, change them out every 6 months.
NOTE: A dirty filter can reduce efficiency, increase operating costs and damage your system.
To schedule your AC’s Spring check-up, please call us at: 661 270 1961
Lic# 877683

AC Dave Call now
AC Dave Heating & Air
commitment to quality customer service
Categories
Tips

It may not be here, but you know it’s on the way…

As we enjoy a week of cooler weather, we know that summer is around the corner. so how can you prepare for soaring temperatures that are on the way?

6 Ways to Prep Your HVAC System for Spring and Summer
  1. Remove Any Condenser Covers. …
  2. Change the Air Filters. …
  3. Clean All Supply Vents and Registers. …
  4. Test the Thermostat. …
  5. Turn On the System. …
  6. Schedule Your HVAC System Maintenance.

AC Dave Heating & Air are now opening our schedules to get you ready for Summer. Call to get your appointment now!

661 270 1961   www.acdaveheatingandair.com

Lic #877683

Categories
Tips

Thermostat doesn’t turn on / thermostat screen is blank

This two-week informational topic will discuss the most common 8 reasons why your thermostat is not working, whether that be that it’s not turning on or that the screen is blank.

WEEK ONE:

Incorrect thermostat setting: If the thermostat has been turned off, its display will be blank. Thermostats should be left on throughout the year rather than being turned off, but accidental adjustments are possible. Verify this setting and ensure the thermostat itself is on.

Dead Batteries: Check your batteries often to ensure this is not the issue. Without batteries, the thermostat cannot turn on or control the heating unit.

No electrical Power: Some thermostats are hardwired and powered by the home’s electrical system. A tripped breaker or blown fuse in the electrical panel may prevent the thermostat from receiving power. Resetting the power or replacing the blown fuse will correct this issue.

Loose Wiring: If thermostat wiring becomes loose, its operation may be disrupted. An HVAC technician here at AC Daves Heating and Air is able to identify issues with wiring and electrical connections within the thermostat/ Sometimes these issues are repairable, while other times it may be necessary to replace the thermostat.

Please make sure you always put your HVAC system in the hands of a licensed Technician. Call us if you need assistance. TEL: 661 270 1961.  LIC # 877683

 

 

Categories
Tips

Furnace Filter become clogged faster than Usual… Part3

Furnace Filter become clogged faster than Usual… Part 3

High levels of indoor contaminants:

High levels of indoor air pollutants create a bigger burden for furnace filters and they become clogged much faster. Filters typically don’t last as long in homes with indoor pets or where indoor smoking takes place. Weatherizing the home to prevent winter heat loss traps contaminants indoors which can increase this issue.

If you haven’t changed your winter filters out yet, you may want to start thinking about it soon. If you are unsure what filters you need, or you would prefer a professional Licensed HVAC company to come out and do a service call, please call us here at AC Dave Heating & Air. We are here to serve.

Tel: 661 270 1961   www.acdaveheatingandair.com

LIC #87768

Categories
Tips

LACK OF MAINTENANCE APRIL 11

Regularly scheduled maintenance by a LICENSED service contractor is a MUST to keep your system in proper working order. Many of the most common Heating & cooling system repairs can be avoided with proper maintenance by a certified service contractor. You have likely invested thousands of dollars in your home heating and cooling system, so why not protect that investment? If you neglect to perform regular maintenance you will most likely experience unexpected and costly breakdowns, increased energy costs, poor performance, and frustration. Let’s face it; Living in California can be uncomfortable in the Winter and Summer months, so why wouldn’t you want your heat and cooling source to be in tip top condition?

Protect your investment, and gain peace of mind. Call AC Dave Heating & Air to have one of our Licensed HVAC service team inspect your system today!
Tel: 661 270 1961 http://www.acdaveheatingandair.com LIC#877683

Categories
Tips

My Air Conditioner Is Not Cooling

My Air Conditioner Is           Not Cooling


How to fix it
:

An air conditioner that is running but isn’t cooling is one of the most common problems. Unfortunately, it has a number of potential causes. It could be a dirty air filter, low refrigerant level, or a blocked condensate drain. You can also check for ice around the coils or a dirty outdoor compressor. Or, you may need to add more coolant to your system. Another problem: it may simply be too hot outside to cool your home to your liking. Most air conditioners can only cool to about 20 degrees lower than outside air temperatures.

Contact AC Dave Heating & Air to schedule a technician if your Air conditioner is running but isn’t cooling. 661 270 1961.

Categories
Tips

20 most common Winter Heating System Problems Feb 28 2022

The heating system shuts off shortly after coming on. Feb 28, 2022
 
Heating equipment typically cycles for 10 to 15 minutes at a time. When the system starts up and shuts down again within a minute or two, this issue is known as short cycling. Short cycling has many causes – despite its cause, this issue causes damage to the HVAC equipment along with discomfort in the home, leading to higher heating bills and more frequent system repair needs.
 
1. Thermostat malfunction.
Faulty electrical connections, dirty temperature sensors, improper location of the device, or even an unlevel older mercury model are all issues that cause short cycling stemming from the thermostat. Gentle cleaning of sensors, recalibration, repositioning, or replacement may be used to solve these issues.
 
2. Improper thermostat anticipator calibration.
Some older manual thermostats have adjustable heat anticipators which warm up the interior of the thermostat in order to prematurely end a heating cycle. This is done in anticipation of residual heat in the ducts, allowing it to reach the living areas while avoiding overheating the space. Improper calibration of the anticipator can end heat cycles too early, causing short cycling. They can be adjusted, or the entire thermostat can be upgraded.
 
3. Overheating can be caused by poor airflow.
Dirty air filters and closed room vents restrict airflow through the furnace, which causes interior components to overheat. The furnace’s limit switch shuts down operation when internal temperatures are too high for safe operation. Replace the furnace filter and check all room vents to ensure they are fully open. A blocked flue pipe can also cause furnace overheating – blockages must be found and cleared not only to prevent short-cycling but possible carbon monoxide exposure in the home.
4. Faulty Flame Sensor In Furnace.
The flame sensor detects the presence of a flame when the furnace’s gas valve is open, working to prevent dangerous gas leaks and explosions. When it becomes dirty from soot, it may not detect the flame and the system shuts down shortly after starting as a safety measure. The existing sensor can be cleaned or replaced if broken, as corrosion is a common cause of damage to the component.
 
5. Faulty furnace draft inducer motor.
Many newer furnaces feature a draft inducer motor that exhausts combustion gases leftover from the prior heating cycle. If its air pressure switch does not detect proper airflow through the heat exchanger, it shuts the furnace down as a safety measure. This malfunction may be caused by an obstructed flue pipe or a fault in the pressure switch or the motor itself.
 
6. Oversized heating equipment.
When a heating system is installed that is too big for the home, it produces larger amounts of heat fast – this is not a good thing. Air heats up quickly, and the thermostat shuts down the heating cycle once the set temperature is detected. Repetitive short cycles wear out components, leading to higher energy consumption and more equipment breakdowns. Replacement is the only solution.
 
If you have any questions regarding your heating or cooling system, please contact us: 661 270 1961  http://www.acdaveheatingandair.com  Lic#877683
Categories
Tips

​7 Summer Maintenance Tips For Your HVAC System

While the sun is up, you want to stay indoors and let your air conditioner cool you all day. Surely, you do not want to skip a second without feeling the cool air on your skin. To stay this way this summer, you must learn how to make your HVAC system ready for the heatwave. Here are seven (7) easy and simple maintenance tips from AC Dave Heating & Air that you should not miss.
1.Thermostat Keeping your thermostat in shape is one way of optimizing the performance of your HVAC system this summer. If you wish to customize your home’s temperature based on your individual comfort needs, a programmable thermostat can do the job. While it lets you save money on the energy bill, a smart thermostat also prevents your A/C unit from premature damage during the hot season.
2. Filter Check your air filters periodically. If you see any sign of dirt buildup, then replace it as needed. Air filters should be replaced or thoroughly cleaned to allow cool and clean air to circulate throughout the house. Take note, clogged filters due to dirt leads to poor airflow, health issues, and other problems.
3. Outdoor Unit Do not neglect to check your outdoor unit. Make sure that it is free from any blockage or debris that can make it difficult for the system to pull in air. Remove any unwanted plant or shrubbery that grows close to it and make it completely clean.
4. DuctworkWalk around the house and inspect your ductwork. See to it that there are no obstructions to the passage of air. Now, you want to make sure that it is clean, so you have to bring in the experts for the work. Your system has to have clean ducts to work at the optimized performance.

5. Tune-up A routine tune-up and maintenance are necessary to your HVAC system. As the temperature rises, your system works harder to provide your comfort needs. In return, do it a favor by scheduling a tune-up service regularly.
6. InspectionSurely, you want to keep your system in good condition all year round, especially during these warm months. Well, a professional HVAC inspection does it for you. Upon the visit of your local technician, you may ask questions and ideas on how to help your system operate efficiently.
7. DrainageJust like how you take care of your outdoor unit, you should also clear your drainage hole of dirt and blockages. It is easy to clean the hole so you can do it yourself. But, for better results, leave the job to the professionals. Do not let the heat crack your cool just because your air conditioner has blown out. Prevent your HVAC system from malfunctioning this summer with these maintenance tips.

If you are more comfortable with professionals taking care of your system call AC Dave Heating & Air 661-270-1961.